Flow induced oscillation of two rigid rectangular plates in a side-by-side configuration

The present work is an experimental study of two oscillating rigid plates placed in side-by-side configuration, hinged at their leading edges, subjected to low subsonic flow. This problem is investigated using smoke-wire flow visualization, hot-wire anemometry, and time resolved particle image velocimetry. It is found that beyond a critical Reynolds number, the plates set into oscillatory motion. This critical Reynolds number depends on the gap between the plates. It is also seen that this value of Reynolds number, at lower values of gap to thickness ratio (<7) is significantly higher than that of the single plate configuration value. The frequency and amplitude of the oscillating plates at various gaps and Reynolds numbers have been studied and compared with the characteristics of an oscillating single plate. It is also found that depending on the gap and acceleration of the free-stream, there exist two modes of oscillation - (i) in-phase and (ii) out-of-phase. For gap to thickness ratio less than 10, only in-phase oscillations take place for all values of free-stream velocity considered in the present work, whereas, when this ratio is greater than 10, the mode of oscillation depends on the initial conditions up to a certain free-stream velocity, beyond which the plates switch to in-phase mode. Smoke wire flow visualization technique along with time resolved particle image velocimetry reveal that the vorticity distributions around the plates are responsible for the initiation of the two modes of oscillations.     

A semi-analytical numerical method for time-dependent radiative transfer problems in slab geometry with coherent isotropic scattering

We describe a semi-analytical numerical method for coherent isotropic scattering time-dependent radiative transfer problems in slab geometry. This numerical method is based on a combination of two classes of numerical methods: the spectral methods and the Laplace transform (LTS_N) methods applied to the radiative transfer equation in the discrete ordinates (S_N) formulation. The basic idea is to use the essence of the spectral methods and expand the intensity of radiation in a truncated series of Laguerre polynomials in the time variable and then solve recursively the resulting set of “time-independent” S_N problems by using the LTS_N method. We show some numerical experiments for a typical model problem.     

基于LabVIEW空间瞬态光信号处理技术

分析了待探测的瞬态光信号、背景光信号和高频干扰信号频率的特性,利用LabVIEW软件平台设计虚拟仪器，进行信号处理和分析.设计了数字滤波器，对采集到的信号进行数字滤波，对滤波后的目标信号进行谱估计，得到功率谱密度.试验结果表明，该方法设计简单，运行可靠，滤波效果显著.     

一类暂留稳定过程的极限定理

本文研究了Ａ型暂留稳定过程在无穷远处的收敛速度，给出了一个重对数律．同时我们也得出了这类过程在起始点附近的一些性质．这些性质推广了［１］中的结果     

Resonance method for IR sensing

A highly sensitive method for infrared radiation detection based on thermal resonance in an active bolometer is set forth. An active bolometer is a self-oscillating system consisting of an IR-sensitive cell in a feedback circuit of an adjustable proportional controller. The analysis of an active bolometer autonomous (dark) dynamics reveals that with a generalized gain factor A variation the system evolves from relaxation type towards oscillating and self-oscillating type. When A=A_c, where A_c is a critical value of the generalized gain factor A, the steady state loses stability through self-excited thermal oscillations. The resonance in a system weakly perturbed by IR radiation modulated at self-oscillation frequency q₀[1+exp(iω_ct)] is considered. It is shown that in a small precritical vicinity =(A−A_c)/A_c of the gain factor the amplitude of forced thermal oscillations is proportional to q₀/A_c. The D^* calculation reveals that the detection power of a passive (A=0) bolometer increases with feedback introduction by a factor of 1/||. The detection powers of feasible versions of an active bolometer are compared.     

Fluid and diffusion limits for transient sojourn times of processor sharing queues with time varying rates

We provide an approximate analysis of the transient sojourn time for a processor sharing queue with time varying arrival and service rates, where the load can vary over time, including periods of overload. Using the same asymptotic technique as uniform acceleration as demonstrated in [12] and [13], we obtain fluid and diffusion limits for the sojourn time of the M_t/M_t/1 processor-sharing queue. Our analysis is enabled by the introduction of a “virtual customer” which differs from the notion of a “tagged customer” in that the former has no effect on the processing time of the other customers in the system. Our analysis generalizes to non-exponential service and interarrival times, when the fluid and diffusion limits for the queueing process are known.     

To the problem of energy recuperation in gyrotrons

A relatively high level of the minimal electron energy at the gyrotron output even at very large spread in pitch factor is explained. An estimation of the recuperation efficiency, which can be obtained due to this effect, is given.     

On acoustic and electric waves diffraction in piezoelectric medium by a permeable half-plane crack

The problem of electric and acoustic waves diffraction by a half-plane crack in a transversal isotropic piezoelectric medium is investigated. The crack is assumed to be electric permeable and free of tractions. The so-called “quasi-hyperbolic approximation” [15] is adopted. Applying Laplace transformations and Wiener–Hopf technique a closed form solution is obtained. By the means of Cagniard–de Hoop method a detailed dynamic full electroacoustic wavefield’s investigation is conducted. Mode conversion between electric and acoustic waves, effect of electroacoustic head wave, Bleustein–Gulyaev surface wave and the wavefield structure depending on the type of the incident wave (acoustic or electric) and its angle of incidence are analyzed in details. The dynamic field intensity factors at the crack tip depending on the angle of incidence and on time are derived explicitly. Numerical analysis is presented.     

Physics possibilities at India-based Neutrino Observatory

In this talk I review the physics possible at India-based Neutrino Observatory (INO). I discuss the improvement in the precision of currently known quantities and the possibility measuring the presently unknown quantities.